The Rxol Oil Spill Dispersant Type - II  to be used  to be used is 1 litre per 15–20 m2 as tested on a spillage of BH crude oil. The Rxsol Oil Spill Dispersant Type II uses non-ionic surfactant formulation with exceptional dispersing strength when applied with agitation can break up oil slicks, grease masses, sludge, general dirt and grime to leave a high clean surface. Suitable for use at sea, docks or in port.

For Use in Sea (Oily Water Surface) : -

By Aerial Spraying

The aircraft using the appropriate form of spraying equipment which has been tested and found satisfactory .may spray Rxsol Oil Spill Dispersant Type II ,over the sea, the product being used neat.

By Boat:
Direct a hard coarse spray surface at the surface of the spill with nozzle pressure of 80 to 100 psi, continually move the stream of water over the spill.


For Use in Oil Spill in case of Fire : -

Handle the same as for dispersing oil spills, moving a narrow coarse spray over burning Oil and fuel  surface. In emergencies, foam pick up nozzles may be used. But air intake at the nozzle should be covered to give a harder stream of water.

For Use in Oil Spill at Shore:-

Wash off the spill by directing a hard course stream of Rxsol Oil Spill Dispersant Type II directly at the surface and rinse off spill. Alternatively, work the dispersant over the spill surface and rinse off with strong jets of water.The quantity of Rxsol Oil Spill Dispersant demanded depends on the size of contamination in the affected area.Repetition of the cleaning process may be necessary, until oil–spill elimination is complete.

On Ship:-

Spray the required quantity of the product, with the appropriate spraying equipment, over the oil spill. After spraying  mix thoroughly using a brush, mop, sponge or any other stirring device feasible to move with rapid and irregular action.Pour water over the treated surface and mix vigorously.Rinse thoroughly by applying high–pressure Machine or any other available source.Repeat cleaning if require necessary.